Today I took part in a set design workshop, the workshop included an induction into using the machines in the wood shop room. The first half of the workshop was a run through of all the health and safety precautions that needed to be followed while using the machines. I was shown how to use a range of machines such as, belt sanders, hacksaws and a range of drills. The induction highlighted all the safety wear that must be worn by using the machines, the safety equipment included; gloves, protective eyewear, dust masks and full body suits for welding. After being shown how to use the equipment in the correct way, I went on to make my own frame to be used for an exhibition. Making my own props for the exhibition would be and cheap and efficient way  to create the outcome I desired for the exhibition.

The first step to making a frame, is the cut the piece of wood at a 45 degree angle on one side. Once I had cut my wood to the correct measurement I then used a clamp to connect the two parts of wood together. After clamping the wood together I proceeded to drill two alternate holes in each, this is where the pieces of wood would be connected. After drilling the holes I then placed a screw in each of the holes, with a drill I secured the screws within the wood. After doing this I could then remove the clamp. The last stage was to add a piece of ply wood to the corner for extra support. This was attached using a staple gun.

Overall I enjoyed this set design workshop, I now feel confident to use the machines in the wood shop room to create a frame or a plinth for the upcoming exhibition. Making my own accompaniments for any exhibition is a good future skill to have and also saves a considerable amount of money.